How to Boost a T

1. Measure out 8 inches of the insulated wire. This wire you can get from a nearby electronic shop or a hardware shop. Measure off 2 inches of the wire and bend it into a right angle.
2. Wrap the wire around the pen five times, starting from the point where the wire was bent.
3. Pull the pen out from the loops. Gently pull apart the loops from one another until the distance between loops is about 1 inch.
4. Measure and bend 1 inch from the long end of the wire. Strip off the vinyl insulation ½ inch from the end using the stripping device on the wire cutters.
5. Remove the rubber plug from the external antenna cover on the back of your mobile phone. Insert the stripped end of the wire into it and tape it so that it stays in place. You should see a two-to-three-bar increase in reception.
6. Note that not all phones have an external antenna hole. If your phone doesn't, then simply tape the copper wire to the back of the phone near the top.